Your write-up here has helped me configure these arrays multiple times. A sincere thank you is in order! You are commenting using your WordPress. You are commenting using your Google account. You are commenting using your Twitter account. You are commenting using your Facebook account.
Notify me of new comments via email. Notify me of new posts via email. Blog at WordPress. Niktips's Blog Virtualization and Automation. USB to serial adapters ». Check configuration When you configure active and passive paths you assume that first path listed is to controller A and second path is to controller B.
Like this: Like Loading Leave a Reply Cancel reply Enter your comment here Fill in your details below or click an icon to log in:. Email required Address never made public. Name required. The example provided in this section are taken from Windows Server R2.
Click Add to add a new device entry. Pay close attention to the instructions in the dialog box for string formatting. Click OK. Adding the new MPIO device entry requires a reboot. A Reboot Required dialog box will be displayed. Choose Yes or No depending on what other management or application tasks you are performing, but keep in mind that a reboot is required for the new MPIO device settings to take effect. If you choose not to reboot immediately and click No. A success message will be shown after adding the new device entry.
Choose Yes or No depending on what other management or application tasks you are performing, but keep in mind that a reboot is required for the new settings to take effect. This section describes how to update these timer values specifically for Windows Server R2 and R2 Service Pack 1 as the methods differ from what can be accomplished with newer versions of Windows Server.
Type is boolean and must be filled with either 0 disable or 1 enable. By default, it is disabled. Specifies a custom path recovery time, in seconds. This is the length of time before the server attempts path recovery.
0コメント